Filter
Top Products
Default Settings
Switch Selections - All switches are placed in the Off position (default) for shipping.
This will result in the following operating configuration:
Communications:
(1)
Protocol:
(1)
Sensor:
Receive Buffer:
Mode:
Label Sensor:
Backfeed:
External Signals:
8 data bits, no parity, 1 Stop bit, 9600 Baud
Ready/Busy
Gap Sensor
Single Job
Batch/continuous
Sensor Used
Disabled
Disabled
Software Default Settings - The printer stores the software settings upon receipt and
uses them until they are again changed by receipt of a command containing a new
setting. These settings are stored in non-volatile RAM and are not affected by
powering the printer off. The printer may be reset to use the default software settings
by depressing the LINE and FEED keys simultaneously while powering the printer
on. This will result in the following default configuration:
CL608 and CL612 CL408 and CL412
Print Darkness “2” “3”
Print Speed 6 in. per sec. 4 in. per sec.
Print Reference Vertical = 0001, Horizontal = 0001
Zero Slash
Auto On Line Enabled
Once the default operation is completed, a “SATO DEFAULT COMPLETED” message
will be displayed on the LCD panel or a single “beep” will be heard if the printer does
not have an LCD panel. The printer should be powered off while this message is being
displayed (or after the “beep” is heard. This saves the default settings in the EEPROM
where they will be automatically loaded the next time the printer is powered on.
PRINTER ADJUSTMENTS
The LCD Panel is used in conjunction with the LINE and FEED switches by the
operator to manually enter printer configuration settings. Many of the settings can
also be controlled via software commands and in the case of conflict between
software and control panel settings, the printer will always use the last valid setting.
If you load a label job that includes software settings and then enter a new setting via
the Operation Panel, the manually set values will be used by the printer. If you set
the values manually and then download a job with software settings, the software
settings will be used.
(1) Active only if an RS232
Interface Card is installed.
SATO DEFAULT
COMPLETED
Section 2. Installation and Configuration
Page 2-249001035 Rev. ESATOCL SeriesPrinters