Filter
Top Products
PCMCIA MEMORY CARDS CL408 and CL412
Description
The Memory Card Option provides the connectors and interface board for two
PCMCIA memory cards slots, Slot 1 and Slot 2. The Memory Card Slots are accessible
from the Back Panel. The printer memory can be expanded up to 4MB.
Type SRAM
Applicable Specifications PCMCIA Version 2.1 (JEIDA Version 4.1)
Size 128KB, 256KB, 512KB, 1MB or 2MB
Connector Pins 68
Battery Approximately two years (manufacturer dependent)
Write Protect Yes
Low Battery Detect Yes
Installation
Instructions for installing the Memory Card Option are included with the installation
kit.
Error Handling
Memory Card error conditions are indicated to the operator using a combination of
the ERROR LED on the front panel, the LCD display and the audible indicator.
ERROR DESCRIPTION INDICATION REMEDY
Low Battery - Low battery
condition is detected when printer
is powered on.
STATUS LED: Red Blinking
Audible Beep: 1 long
Display: Card Low Battery
Depress LINE key to print Card
Status.
Replace Memory Card battery.
Note that all data will be lost when
the battery is removed.
Card R/W Error
1. No card is inserted.
2. Card is write protected.
3. Invalid store/recall number.
4. Card has not been initialized.
STATUS LED: Red
Audible Beep: 1 long
Display: Card R/W Error
Printer must be powered off to
reset.
1. Insert card into selected slot.
2. Remove write protect tab.
3. Correct program
4. Initialize card with BJF command
Warning
1. Duplicate number.
2. Data not in print area.
3. Data overflows card memory.
Audible Beep: 1 short
Display: None
Printer will ignore invalid
commands.
1. Correct program.
2. Correct program.
3. Use card with more capacity.
Appendix D: Optional Features
PageD-89001035Rev.E SATOCLSeriesPrinters