Filter
Top Products
CALENDAR ALL MODELS
The Calendar Option allows the date and time to be maintained in the local
printer rather than using the system clock. It consists of a daughter PCBA containing
a clock IC, a lithium battery and a EEPROM. This assembly replaces the EEPROM on
the main pcb assembly. A qualified technician should perform the upgrade as it
requires modifications to the main PCB assembly. Please call SATO Technical Support
if you need to add this option to an existing printer in the field.
INTERFACE CARD ALL MODELS
The CL printers have user changable interface cards. The Interface Card is
accessible from the Rear Panel and is retained by two screws. Use the following
procedure to replace an interface card.
1. Turn power off both the printer and the host and remove the power and interface
cables.
WARNING: Never connect or disconnect interface cables (or use a switch box) with power
applied to either the host or the printer. This may cause damage to the interface
circuitry and is not covered by warranty.
2. Remove the two Interface Card Retaining Screws.
3. Grasp the Interface Card and pull it out of the connector.
4. Place the new Interface Card in the slot and press inward firmly until it is
properly seated.
5. Replace the two Interface Card Retaining Screws.
6. If the new Interface Card is for a serial interface, set DSW1 for the proper
operation. See page 2-22 for the RS232 Transmit/Receive settings.
7. Connect the interface cable to the connector.
Appendix D: Optional Features
SATOCLSeriesPrinters9001035Rev.EPageD-9