Filter
Top Products
2-57
Section 2 Basic Operations
Using the Head Up/Down Lever
Alternate the head height according to the media you use.
Use the head up/down lever for alternating the head height.
(See the figure below)
2
Open the cap cover and loosen the head fixing screws (2
pieces) with a screw driver.
3
Alternate the height of the head with the head up/down
lever.
Generally, preset the head up/down lever up for glossy vinyle chloride and
matted vinyle chloride, and preset the head up/down for banner and FF.
When the paper thickness is 0.5 mm or more, preset the head up/down lever
up regardless of media type.
When the head is rubbed with the media due to media floating, preset the
head up/down lever down even for the thinner media.
Head fixing screw
Head up/down lever
Cap cover
Up (for thinner media (standard))
Down (for thicker media)
1
Enter SERVICE menu and execute HEAD HEIGHT ADJ
on the operation panel.
#ADJUST HEIGHT
>
#ADJUST HEIGHT
>EXECUTING