Filter
Top Products
2-70
<Ink Charge After Head Washing>
Charge the ink after head washing before printing when the printer is
leaved for a long time.
Enter to “SERVICE” menu and select “INK CHARGE” on the
operation panel.
Insert the ink cassettes and charge the ink.
Leave the printer for at least one hour after completion of ink charging.
Check moisture of the wiper sponge.
Perform the test print.
When the print dot-off occurs during the test print, perform slight
cleaning in the “CLEANING” menu.
(See page 2-42.)
#SERVICE
>INK CHARGE
- The printer performs fill cap operation to keep the good
head condition at first 20 hours after print wait state and
every 3 days.
It is recommended to keep the printer ON except when the
printer is not used for a long time.
Avoid leaving the printer with no ink for one month or more
for head protection.
- Do not open and close the rear cover and do not lift and
push down the levers during service cleaning and head
washing.
If doing so, the printer may start service cleaning and head
washing from the begining.
NOTE
NOTE
- The ink of about 200cc is used for the ink charge. If the
cartridge in which the remaining amount of ink is less than
200cc has been inserted, replace it with the cartridge that
contains the ink more than 200cc.