Filter
Top Products
4-9
Section 4 Heater Controller Operation
(8) Preheat by manual operation
The front heater, print heater, and rear heater start to heat until they
reach the set temperature by pressing simultaneously respective
ON/OFF buttons on the heater panel.
NOTE
Simultaneous pressing
Turning on respective heaters in prior to the print can shorten the
heater temperature rise waiting time at the start of printing.
- After the heating started by manual operation, the heaters
turn off automatically through the delay time and standby
time set by the parameters.
- During the printing, these buttons function as normal ON/
OFF buttons.
Parameter Setup Mode
[Additional functions available from V2.00 or later]