Filter
Top Products
Timer Operations
170
Timer Operations
The Timer function allows you to store a fax job to be performed automatically
at a specified time. Up to 59 timer jobs can be stored at any one time, and the
time of each can be specified up to a week in advance.
You can use this function to take advantage of lower off-peak rates without
having to be there when the operation is performed.
♦ The timer function cannot be used for e-mail transmissions.
♦ The DOCUMENT key cannot be used for a timer transmission.
Initial procedure
To store a timer job, first perform the following procedure. After you have
completed this procedure, go to the procedure for the specific job you want to
store (see the following pages).
1
Press . (Flip up the Rapid Key
overlay if it is down.)
2
Make sure that “SET” is selected and
then press .
3
Press or to select the desired operation and then press
).
Note: “CONFIDENTIAL TX MODE” stands for “confidential transmission
mode”.
4
Enter a two-digit number for the hour (“01” to “12”) and a two-digit
number for the minute (“00” to “59”).
TIMER
X/>
START/
ENTER
START/
ENTER
Display:
TIMER MODE
1=SET
2=CLEAR
TIMER SET
1:SEND MODE
2:BROADCAST MODE
3:CONFIDENTIAL TX MODE
4:POLLING MODE
5:SERIAL POLLING MODE
all.book Page 170 Thursday, May 13, 2004 8:51 AM