Filter
Top Products
Optional Settings
209
7. Optional
Settings
Setting 28: DISTINCTIVE RING
This sets the ring pattern to which your fax will answer if you subscribe to a
distinctive ring service. Press or to select a ring pattern and then
press . See page 199 for more details.
♦ Initial setting: OFF
Setting 29: VERIFICATION STAMP
Select ON if you want the machine to stamp each original document page as
it is scanned. After scanning, you can check to see if all pages have been
stamped to verify that no double feeds occurred. Select OFF to turn the
function off. Press or to make the selection and then press .
Note: To use this function, your dealer must install the Verification Stamp
option.
♦ Initial setting: OFF
Setting 30: DEFAULT COPY RESOLUTION
Use this setting to select the default copying resolution (the resolution used for
copying if a setting is not made with ). Press or to select
STANDARD, FINE, SUPER FINE, or ULTRA FINE, and then press .
♦ Initial setting: FINE
Setting 31: SEPARATE MODE
If desired, you can have the machine draw a sheet of paper from one of the
paper sources after each fax reception (and after each print job if the network
printer option is installed). By loading colored (or large) paper in that source,
each colored sheet drawn will act as a separator that makes it easy to
distinguish where one multi-page document ends and another begins. A
Transaction Report printed after a fax reception will also be printed from that
paper source to act as a separator sheet. To turn on this function, press
or to select YES, select the paper source for the separator paper, and
then press . After turning on the function, be sure to load appropriate
paper in the selected paper source. To turn off Seperate mode, press or
START/
ENTER
START/
ENTER
RESOLUTION
START/
ENTER
START/
ENTER
all.book Page 209 Thursday, May 13, 2004 8:51 AM