Filter
Top Products
Programming Auto-Dial Numbers
42
12
If the dual-line option is installed (and Chain Dial was set to NO in the
above step), SELECT THE LINE will appear. Select LINE-1 if you want the
auto-dial number to use only Line 1. Select LINE-2 if you want the auto-
dial number to only use Line 2. Select AUTO if you want the auto-dial
number to use the first available line. Press or to make the
selection, and then press .
13
Return to Step 5 to program another number, or press repeatedly
to return to the date and time display.
• If you programmed a Rapid Key number, you can write the name of the
party on the label above the Rapid Key.
START/
ENTER
STOP
Chain Dialing for area and access codes
You can also program an area code or access code in a Rapid Key or Speed
Dial number using the above programming procedure. In Step 10, select
“YES” to set the number as a Chain Dialing number.
After you dial an area code or access code using a Rapid Key or Speed Dial
number set for Chain Dialing, the machine will wait for you to dial the
remainder of the number (you can dial the remainder of the number by
pressing a Rapid Key, by pressing the Speed Dial key and entering a Speed
Dial number, or by pressing numeric keys). Note that the remainder of the
number should not be set as a Chain Dial number if programmed in a Rapid
Key or Speed Dial number.
♦ The maximum number of digits that can be dialed at one time by Chain
Dialing is 60.
all.book Page 42 Thursday, May 13, 2004 8:51 AM