Filter
Top Products
11·1
Chapter 11 Support Tools
Select “Read out PARAM” and press the “Enter” key.
Start reading to memory of the personal computer.
The following support tools are available to record (store), and load the contents of the parameter memory.
(Make sure to save the set parameters onto a floppy diskette.)
11-1 Record and load by ladder software (JW-50SP)
(1) Record
Stop operation of the JW-20CM
Record onto the personal computer
After stopping operation, record the parameters of the JW-20CM onto the memory of the personal
computer.
Start operation of the JW-20CM
After recording the parameters onto the personal computer, start operation of the JW-20CM.
After selecting “Start write EEPROM” or “Execution
start,” press the “Enter” key.
Applicable floppy diskettes
Model name
Ladder software (JW-50SP) 3.5-inch 2DD/2HD, 5-inch 2DD/2HD
Multipurpose programmer (JW-50PG) 3.5-inch 2DD
Ladder processor II (Z-100LP2S) 3.5-inch 2DD
Start operation of the JW-20CM
After selecting “PC Run,” press the “Enter” key.
Start PC operation
Select “PC TRANS.”
Select “Read.”
Select “DL. M. stn. PARAM.” or “DL. S. stn.
PARAM.”
Set as the function setting condition of the
connected network module.
After selecting “PC stop,” press the “Enter”
key.
· Communication adaptor supplied
with JW-50SP
Convertor supplied with JW-50SP
· Control module connection cable