Filter
Top Products
8·31
Operation procedure
Turn ON the power switch on the master station PC
Connnect support tools
Stop PC operation
Stop operation of the remote I/Os (parameter address 003777(8) = 00(H))
Set the operation mode of the remote I/Os
Set the number of slave stations connected
Set the remote I/O top address
Set the number of slave station I/O points
Set the blanks between stations
Set the top address of remote I/O slave station 01
Set the top address of remote I/O slave station 02 to 77
Set the number of I/O bytes for each slave station
(If the master station PC is a JW model)
Set the I/O model type for each slave station
Set the area for special I/O data registers
Write to EEPROM, start operation (parameter address 00377(8) = 81(H))
Set the top flag address
PC operation
End
When using fixed allocation mode When using manual allocation mode
When the master
station PC is a
ZW model
Steps 1 to 8 correspond to the steps on pages 8·38 to 8·44.
1
2
3
4
5
6
[8·35]
[8·40]
[8·42]
[8·35]
[8·38]
[8·39]
[8·43]
[8·44]
[8·36]
[8·37]
[8·37]
In brackets: See page