Filter
Top Products
8·15
Power “OFF” master/slave station
Set output hold switch
· Set this switch whether to "latch" or "turn OFF
all points" of output circuits when the slave
module JW-20RS stops operation.
· In case of using I/O module of JW model, be
sure to setting “HOLD”.
1 When the slave module JW-20RS stopped, the halt output turns “open” and output module
sets “all points OFF”. (See page 8·50).
Remove the setting switch cover of master
module JW-20RS.
· With your fingertips over the top and bottom
of the switch cover, pull the cover towards
you to remove it.
· Keep the cover saved as it must be installed
after switch setting.
Set MODE (function) switch
· Select the model of I/O module that installed
on respective slave module.
The mode switch is set to “2” at delivery.
Positions "3 to F" will be used only by our service
man. Do not set the switch to these positions.
· If the master station PC is JW model, it can connect to the slave modules having "ZW model I/O
module" and "JW model I/O module" on the same circuit.
To the next page
Output hold
switch
Keep *2 switch above as
delivered condition.
[
]
gnitteshctiwS stnetnoC
O/IgnisufoesacnI
ledomWZfoeludom
DLOH"dloH"
TSR
1
"FFOstniopllA"
O/IgnisufoesacnI
ledomWJfoeludom
DLOH"dloh"tagnitteS
eulavgnitteS eludomO/IfoledoM
1ledomWZfoeludomO/I
2ledomWJfoeludomO/I
MODE