Filter
Top Products
11·9
(2) Parameter setting by remote function
This paragraph describes how to set the parameters of other stations’ network module connected on
the satellite net.
This is only available when the target station is within the standard network connection.
Usable support tools are JW-13PG/12PG.
<An operation example using the JW-13PG>
Connect the programmer to the network module
Connect the programmer to the network
module on the satellite net.
Setting mode
Select initial mode.
Display initial mode.
Assign the link
Assign the parameter setting remotely.
Select “LINK” in initial.
Select display mode of “1PG, 2PG1 MODE” in specified link.
Select “TARGET STA.” in 1PG, 2PG1 MODE.
Setting target station
Select the target station to set the parameter remotely.
Change the code from hexadecimal
(H)
display to octal
(O)
display and input the target
station (00
(8)
to 77
(8)
).
Communication with the target station
Initiate communication with the target station.