Filter
Top Products
8·23
Remarks
From the previous page
Writing to the EEPROM, start operation [HEX (hexadecimal), byte]
· Write “81
(H)
” into parameter address 003777
(8)
and write the set parameter contents into the
EEPROM. Then start the slave module.
· After starting operation, the setting value changes to “01
(H)
.”
(Operation example of JW-13PG)
Write 81(H)
Display the contents of address
003777(8)
Screen display of JW-13PG
Setting
value
(H)
Contents
0 0
0 1
8 0
8 1
0 8
Stop operation
Start operation
Writing to the EEPROM, stop operation
Writing to the EEPROM, start operation
Initialize setting values of parameter addresses
03775 HEX 00
03776 HEX 00
I PARAM.
>03777 HEX 01
· Writing time to EEPROM is approximately 0.7 sec. When any error is found for parameter
settings, lights the error code 9F
(H)
by the indication lamp.
· Written contents into the EEPROM are automatically written to the RAM of the slave
module when turning ON the power of the PC. At reading, the PC checks BCC and compares
BCC check code of the parameter memory address (003776
(8)
). When an error is found,
the JW-20RS lights the error code 9E
(H)
by the indication lamp.
· After initialized the parameters, the JW-20RS initializes parameter address 000000 to
003776
(8)
.