Filter
Top Products
References DART 300 Modem
Page 104 2110212 Rev 1.0
Table 12-3: AT [+] Commands in CDPD Mode (continued)
Command Description
+WPNEI=<ip>
Active NEI Write
This writes the specified IP address to the table entry indexed by +WS197 (Active NEI Index).
Changing the NEI entry resets the entry’s CDPD authentication credentials associated with the
entry. The CDPD service provider must also reset the network’s expected authentication
credentials for the new address or registration will be unsuccessful.
If the new value to be written is identical to original value then the authentication credentials are
NOT reset.
Before changing the NEI entry, the modem prompts:
Change c.c.c.c to n.n.n.n?
where c.c.c.c is the current value for the NEI specified by +WS197 and n.n.n.n is the new value.
The expected response is “Y” (upper or lower case); otherwise the NEI is not changed.
+WPNEI?
Active NEI Read
Returns the active NEI, in dotted IP format, from the NEI table as determined by the index in
+WS197 (Active NEI Index). See also +WPCURNEI.
+WPNEILIST
NEI List
Displays the four-entry NEI table, with the type and status of each.
Response:
1 ddd.ddd.ddd.ddd type status
2 ddd.ddd.ddd.ddd type status
3 ddd.ddd.ddd.ddd type status
4 ddd.ddd.ddd.ddd type status
where:
ddd.ddd.ddd.ddd is the NEI in dotted-IP address form
type is:
‘P’ for point-to-point NEIs,
‘*’ for the auto-registration NEI (indexed by +WS176)
status is: “Registered” or “No”