Filter
Top Products
References DART 300 Modem
Page 106 2110212 Rev 1.0
Table 12-3: AT [+] Commands in CDPD Mode (continued)
Command Description
+WS<n>=[x]
WS-register Write
Sets the contents of the specified +WS-register (n) to the new value (x).
Var. Range
n Valid +WS-register number (See Table 12-5 for values).
x as determined by the +WS-register (n). If not specified then zero (0) is assumed.
Result Codes:
OK +WS-register n set to x.
ERROR Invalid +WS-register value (n) or, setting (x) outside of permitted range.
+WS<n>?
WS-register Read
The contents of the specified +WS-register (n) are returned to the host (DTE) as ASCII decimal
digits.
Var. Range
n Valid +WS-register number (See Table 12-5 for values).
Result Codes:
OK +WS-register n reported.
ERROR Invalid +WS-register value (n).
+WVCALLERIP
Caller IP (PAD modes)
Reports the IP address of the currently connected remote terminal. The response is in
dotted-decimal format ddd.ddd.ddd.ddd with leading zeroes. If there is no active session,
the value returned is all zeroes.
+WVFRIEND=
<ip>[port]
Active Friend Write
This writes the specified IP address and optional port to the table entry indexed by
+WS213 (Friend List Index). Including a port number allows the entry to be used for “quick”
dialing (see D (Dial)). If the port is excluded in the parameters, the default 0 will be used.
Before changing the entry, the modem prompts:
Change c.c.c.c.q to n.n.n.n.p?
where c.c.c.c.q is the current value for the NEI and port specified by +WS213 and n.n.n.n.p is the
new value. The expected response is “Y” (upper or lower case); otherwise the NEI is not changed.
This table is stored in non-volatile memory and is preserved across all mode changes, resets, and
power cycles.
+WVFRIEND?
Active Friend Read
Returns the IP address and port, in dotted IP format, of the Friend List table entry as determined
by the index in +WS213 (Friend List Index). This is useful for verification before and after
changes to the table.
+WVFRIENDLIST
Displays the current ten-entry Friend List table. If all entries are 0.0.0.0.0 then the Friends
Only feature is disabled.
Response:
1 ddd.ddd.ddd.ddd.pppp
2 ddd.ddd.ddd.ddd.pppp
…
10 ddd.ddd.ddd.ddd.pppp