Filter
Top Products
Maintaining tape drives
Avaya CMS Sun Fire V880/V890 Installation, Maintenance, and Troubleshooting May 2006
125
Cleaning the tape drive
This section describes how you clean the tape drive.
Note:
Note: CMS computers do not ship with tape drive cleaning tapes. Avaya recommends
that customers purchase at least one cleaning tape as soon as the computer is
installed and in service.
The number of cleaning cycles available on a cleaning cartridge depends on the manufacturer
of the cartridge. Regular cleaning is recommended to maximize tape drive performance. Avaya
recommends that you clean the tape drive once a week or every five (5) data backups,
whichever comes first.
The LEDs on the tape drives indicate when the tape drives need cleaning. See Tape drive
status indicators on page 184. If the Clean LED flashes, either the tape drive heads need
cleaning, or the backup tape needs replacing.
To clean the tape drive:
1. Load the cleaning cartridge into the tape drive.
The cleaning cycle begins automatically, and the Tape LED flashes. When the cleaning
cycle is complete, the cleaning cartridge is ejected automatically. If the cleaning cartridge
does not eject automatically, it may be defective and may need replacing.
2. The first time you use the cleaning cartridge, record the date on the cleaning cartridge.
Each time you clean the tape drive, mark an X in the box. After all boxes are filled, replace
the cleaning cartridge.
3. Return the cleaning cartridge to the plastic protection box.
If the Clean LED continues to flash, repeat the cleaning procedure using a different cleaning
cartridge. If the Clean LED is still flashing, repeat the backup operation with a different tape. If
this clears the signal, the first backup tape is nearing the end of its life. Discard the old tape.