Filter
Top Products
Maintenance
72 Avaya CMS Sun Fire V880/V890 Installation, Maintenance, and Troubleshooting May 2006
9. Insert the PCI card into the slot on the I/O board. Make sure that the card is fully seated.
See the following figure.
When the card is inserted, the amber OK-to-Remove LED lights and a message similar to
the following is displayed on the console window:
10. Rotate the purple PCI retaining clip over the back of the card faceplate until it snaps into
place.
11. Press the hot-plug button for the card you are installing.
After the button is pressed, the following should occur:
● The amber Fault LED for the slot may blink briefly and then turn off.
● The green Power LED lights.
● A message similar to the following is displayed on the console window:
!
Important:
Important: If the Fault LED remains lit after inserting a card, you must shut down the system,
reinsert the card, and reboot the system.
Jun 6 12:55:24 sys_name picld[98]: Device PCI1_CARD inserted
Jun 6 12:57:11 sys_name pcihp: NOTICE: pcihp (pcisch0): card is powered on in the slot
hpc1_slotX