Filter
Top Products
WS 2000 Wireless Switch System Reference Guide7-24
1. To set the SNMP traps, select System Configuration --> SNMP Access --> SNMP Traps from the left menu.
2. Check the type of traps to enable the generation of notification events.
Trap
Category
Trap Name Generates a Trap whenever…
System Traps System Cold Start
The switch’s router reinitializes while transmitting, possibly altering the
agent’s configuration or protocol entity implementation.
Configuration Changes
Check this box to generate a trap when the SNMP access or management
functions are reconfigured.
Low Compact Flash
Memory
The Compact Flash card in the system falls below the amount specified.
Network
Traps
Physical port status
change
The status changes for one of the ports on the front of the WS 2000, such as
if a device is plugged into or unplugged from the switch, or if the link is lost
between the switch and the connected device.
Denial of service (DOS)
attempts
A Denial of Service attack is detected by the switch’s firewall. A new trap
will be sent at the interval specified until the attack has stopped.
SNMP Traps SNMP authentication
failures
An SNMP-capable client is denied access to the switch’s SNMP
management functions or data. This may result from incorrect login
SNMP ACL violation
An SNMP client cannot access SNMP management functions or data due to
an Access Control List (ACL) violation
MU Traps MU associated
An MU becomes associated with one of the switch’s Wireless Local Area
Networks (WLANs)