Filter
Top Products
Getting Started 2-11
3. Add a key to Key #1, and use that key with the mobile unit. The keys consist of 26 hexadecimal (0-9, A-E) characters.
When finished, click the Ok button to close this screen an return to the WLAN Security screen.
4. Click the Apply button in the WLAN Security screen to save changes.
Mobile Unit Access Control List (ACL)
This list is used to specify which mobile units can or cannot gain access to the WLAN. The list employs an adoption rule for
allowing or denying specific mobile units by way of exception. By default, all mobile units can gain access.
Step 9: Test Connectivity
At this point, the switch is set up to allow mobile units to access the LAN.
1. Go to the mobile unit and ensure that it is set up as a DHCP client.
2. Set the mobile unit for WEP 128 encryption and set the same key as the one that was entered in the WEP Key Settings
dialog. It may be necessary to reboot the mobile unit after changing the settings.
3. Open a Web browser and type the IP address: 192.168.0.1.
The WS 2000 Switch Management screen should appear. If not, go back to the wired system used to configure the
switch and see if the mobile device appears in the MU Stats screen (Status & Statistics --> MU Stats). If it does not
appear on the MU Stats screen, recheck the network and WEP settings on the mobile device.
4. In the Web browser, enter a URL for a site (such as www.symbol.com) on the WAN. If the site does not appear, go to
the WAN Stats screen (Status & Statistics --> WAN Stats) to review the status of the WAN connection.