Filter
Top Products
1740A/1750A Series Waveform/Vector Monitor User Manual 3-5
Using the Menus
General menu information here is followed by detailed
information about each menu:
FILTER, CURSOR, LIN SEL,
PRESET, CONFIG, GAIN
and CRT. To set instrument operating
parameters, see
CONFIG and CRT menu information.
General Menu Information
Push the desired menu button to obtain an on-screen menu
readout.
Multi-Use Bezel Controls and Buttons
Menu selections appear along the right side of the screen.
Descriptive labels, when present, appear in
ITALIC text. Ac-
tual selections appear in
STANDARD text, with the present
selection outlined. Use the five buttons along the right side of
the CRT (referred to as bezel buttons) to change the selec-
tions.
The center three controls under the CRT are referred to as
Left, Center, and Right bezel controls. Control functions
vary with menu choice; a readout just above each active con-
trol shows its present function. These controls are used as
variable analog controls to set values such as phase, ampli-
tude, and intensity. The left control is also used to select
categories within the
CONFIG menu.
Figure 3-1 shows the bezel controls and buttons.
Moving Between Menus
Selecting a second menu removes the present menu display,
but the functions typically remain active (with the menu LED
remaining lighted to show this state). To reinstate a menu
display, push that menu button again.
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176 - FAX 781.665.0780 - TestEquipmentDepot.com