Filter
Top Products
Getting Set Up
2
User Manual
2-25
Turning on the printer
After you have connected the interface cables, you are ready to connect the
power cord and turn on the printer. If you need to turn the printer off, wait
until the display shows Ready before powering it down.
Caution
To avoid damaging the printer, make sure that the voltage
select switch is set to match the AC line voltage for your
location and that the power switch is in the off position before
connecting the power cord.
If you move the printer to a location that uses a line voltage other than the
printer’s current setting, refer to “Changing line voltage” on page C-4 for
information on changing the line voltage selection switch.
1.
Plug the power cord into the printer and into a grounded outlet.
2.
Turn on the printer.
Note
To ensure optimum printing performance and best ink economy,
leave the printer turned on overnight and during weekends. The
printer automatically switches into a standby mode to reduce
power consumption during periods of infrequent use.
9101-50
115
Parallel
Service
port
DIP
AUX
Feeder
PHASER 340
Ethernet®
SCSI Disk
115