Filter
Top Products
4.11 Display Assembly 4 Replacement Procedures
Satellite A50S/TECRA A3X Maintenance Manual (960-534) [CONFIDENTIAL] 4-37
Installing the Display assembly
The following describes the procedure for installing the display assembly (See Figure 4-23 to
4-25).
1. Pass the wireless LAN antenna cables through the slot near the center of the base
assembly.
2. Install the display assembly on the base assembly from the rear of the computer and
secure them with the following screws.
• M2x8B BIND screw x1
• M2.5x8B THIN BIND screw x1
3. Connect the LCD harness to the connector CN5000 on the system board and install
the LCD harness hold plate with the following screw.
• M2.5x8B THIN BIND screw x1
4. Connect the speaker cables (blue, red) to the connectors CN6001, CN6002 on the
system board.
5. Connect the touch pad cable to the connector CN3240 on the system board.
6. Close the display and turn the computer face down. Secure the base assembly with
the following screws from the bottom.
• M2.5x6B THIN BIND screw x9 (“6” in the figure)
• M2.5x14B THIN BIND screw x5 (“14” in the figure)
• M2.5x18B THIN BIND screw x1 (“18” in the figure)