Filter
Top Products
4.22 Wireless LAN Antenna/Speaker/Hinge 4 Replacement Procedures
Installing the Wireless LAN antenna/Speaker/Hinge
The following describes the procedure for installing the wireless LAN antenna, speaker and
hinge (See Figure 4-44 to 4-52).
CAUTION: When installing the speakers, be careful not to touch the metal part of the
speakers. It might damage the speakers.
1. Install the hinges to the display assembly and secure them with the following screws.
• M2.5x4B THIN BIND screw x3 (Right:1, Left: 2)
2. Attach sponges on both the side of each speaker.
Sponge
Left Speaker
Right Speaker
Sponge
Figure 4-52 Attaching sponges
3. Set the left speaker on the base assembly. Pass the left speaker cable (blue) along
the guide on the front of the display assembly and run toward the back side. Secure
the cable with four insulators.
4. Set the right speaker on the base assembly and pass the right speaker cable (red)
toward the back side of the base assembly.
5. Arrange the speaker cables (blue and red) along the guides. Pass the cables under the
insulator and secure them with accetate tapes. Insert the insulator end under the
hinge.
Satellite A50S/TECRA A3X Maintenance Manual (960-534) [CONFIDENTIAL] 4-69