Filter
Top Products
3 Tests and Diagnostics 3.2 Executing the Diagnostic Test
3. Select the test you want to execute and press Enter. When SYSTEM TEST is
selected, the following message will appear:
SYSTEM TEST XXXXXXX
XXX DIAGNOSTIC TEST VX.XX
[Ctrl]+[Break] : test end
[Ctrl]+[C] : key stop
SUB-TEST : XX
PASS COUNT : XXXXX ERROR COUNT : XXXXX
WRITE DATA : XX READ DATA : XX
ADDRESS : XXXXXX STATUS : XXX
SUB-TEST MENU :
01 - ROM checksum
02 – Geyserville
03 -
04 - Fan ON/OFF
05 –
06 - Quick charge
07 - DMI read
08 - DMI write
09 - Thermister Check
99 - Exit to DIAGNOSTIC TEST MENU
↑↓→← : Select items
Enter : Specify
Esc : Exit
NOTE: The menu displayed by your computer may be slightly different from the one
shown above.
4. Select the desired subtest number from the subtest menu and press Enter. The
following message will appear:
TEST LOOP : YES/NO
Selecting YES increases the pass counter by one, each time the test cycle ends and
restarts the test cycle.
Selecting NO returns to the subtest menu after the test is complete.
3-6 Satellite A40 Maintenance Manual (960-458)