Filter
Top Products
4 Replacement Procedures 4.24 LCD cable/Sensor switch/Wireless LAN antenna
Installing the LCD cable/Sensor switch/Wireless LAN antenna
To install the LCD cable/sensor switch/wireless LAN antenna, follow the steps below and
refer to figures 4-38 to 4-43.
1. Stick the wireless LAN antennas.
2. Pass the wireless LAN antenna cables through the hole.
3. Secure the wireless LAN antenna cables with the six acetate tapes (one tape at the
back, five tapes at the front).
4. Install the hinge cap (on the opposite side of the LCD cable side).
5. Install the sensor switch while hooking the latches.
6. Pass the sensor switch cable through the holes and guides and stick the acetate tape.
7. Pass the LCD cable through the holes and guides.
8. Set the LCD cable holder and secure it with the following screw.
• M2.5×4 Tapping screw ×2
9. Set the cable holder and secure it with the following screw.
• M2.5×4 Tapping screw ×1
10. Install the hinge cap (at the LCD cable side).
4-64 Satellite A40 Maintenance Manual (960-458)