Filter
Top Products
4.12 Display assembly 4 Replacement Procedures
Installing the Display assembly
To install the display assembly, follow the steps below and refer to figures 4-19 to 4-21.
1. Install the display assembly on the base assembly.
NOTE: When installing the display assembly, be careful not to pinch or damage any
cables.
2. Press along the edges of the display assembly to secure the latches.
3. Connect the panel sensor cable to the connector PJ3302 on the system board.
4. Connect the speaker cables to the connectors PJ6001 (blue) and PJ6002 (red) on the
system board.
5. Connect the LCD cable to the connector PJ5600 on the system board.
6. Secure the display assembly with the following screws.
• M2.5×6B FLAT HEAD screw ×2
7. Turn the computer face down and secure the display assembly with the following
screws.
• M2.5×16B FLAT HEAD screw ×12 (“16” in the figure below)
• M2.5×6B FLAT HEAD screw ×7 (“6” in the figure below)
• M2.5×3B S-FLAT HEAD screw ×5 (“3” in the figure below)
Satellite A40 Maintenance Manual (960-458) 4-37