Filter
Top Products
4 Replacement Procedure 4.26 Fluorescent lamp
Removing the bezel
1. Without removing the insulation tape, flip the module over again so that the display
screen can face up.
2. Release the latches of the bezel and frame. (On the sides, there are five latches in the
upper area and two latches in the lower area.)
3. Gently remove the double-sided tape from the cell at the reverse side of the bottom of
the bezel and remove the bezel.
4. Remove the double-sided tape remaining at the bottom of the cell and on the reverse
side of the bezel.
CAUTION: Do not damage the TAB when releasing the latches on the upper area.
When removing the bezel, gently remove the top double-sided tape at the
bottom of the surface of the bezel to prevent cell damage. Be careful not to
deform the bezel.
2
1
c
d
Figure 4-65 Replacing 14 Inch TMD fluorescent lamp (3)
4-82 Satellite A40 Maintenance Manual (960-458)