Filter
Top Products
3 Tests and Diagnostics 3.2 Executing the Diagnostic Test
3-8 [CONFIDENTIAL] PORTEGE A600 Maintenance Manual (960-710)
Use the up and down arrow keys to move the cursor to “ERROR STOP”.
Use the right and left arrow keys to move the cursor to the desired option and press Enter.
Selecting YES of ERROR STOP stops the test program when an error is found and displays
the operation guide on the right side of the display screen as shown below:
ERROR STATUS NAME [[ HALT OPERATION ]]
1: Test end
2: Continue
3: Retry
These three selections have the following functions respectively:
1. Terminates the test program and exits to the subtest menu.
2. Continues the test.
3. Restarts the test from the error.
Selecting NO keeps the test running even if an error is found. When an error occurred, the
error status is displayed and one error is added to the error counter.
Table 3-1 in section 3.6 describes the function of each test on the subtest menu. Table 3-2 in
section 3.19 describes the error codes and error status for each error.
3.2.2 H/W initial information setting tool
After selecting this test, the following menu appears in the display.
###################################################################
###### Repair Initial config set ####
###################################################################
* 1 ………………………… Entry of the DMI information *
* 2 ………………………… DMI information save *
* 3 ………………………… DMI information recovery *
* *
* 9 ………………………… Exit to Repair test menu *
*******************************************************************
... Press test number [1-3,9] ?
For more details on this test, refer to the section 3.3.
3.2.3 Heatrun test program
Heatrun test starts executing the same subtest as 3.23 RUNNING TEST.
For more details on this test, refer to the section 3.4.