Filter
Top Products
4 Replacement Procedures 4.24 Touch pad/Fingerprint sensor board
4.24 Touch pad/Fingerprint sensor board
Removing the Touch pad/Fingerprint sensor board
To remove the touch pad/fingerprint sensor board, follow the steps below and refer to Figure
4-35 and 4-36.
1. Disconnect the membrane switch FPC from the connector on the touch pad.
2. Disconnect the fingerprint sensor board FFC from the connector CN9810 on the
fingerprint sensor board.
3. Turn the cover assembly face up and remove the touch pad adhered with the double-
sided tape.
4. Remove the TPD BTN cover adhered with the double-sided tape while releasing the
latches.
Touch pad
TPD BTN cover
Fingerprint sensor
board FFC
Membrane switch FPC
Latch
Touch pad
Fingerprint sensor board
CN9810
Figure 4-35 Removing the touch pad/fingerprint sensor board (1)
4-62 [CONFIDENTIAL] PORTÉGÉ A600 Maintenance Manual (960-710)