Vanguard Managed Solutions 6455 Network Card User Manual


 
4-6 Powering Up Your Vanguard 6435/6455
Front Panel Display Messages
Front Panel Display Messages
Description This section consists of a table explaining all the Vanguard 6435/6455 front panel
messages:
Display Message Description
BootPROM Vn.n Indicates the revision of the Boot Prom software. This
is displayed after power up and when the node is reset.
Booting ONS The node is booting (operating software is being
started).
Coldload Done When the image has successfully loaded into FLASH,
this message appears for 5 seconds.
CPU Util. nn% Percentage of CPU capability being used.
Writing to FLASH The Cold Loader is loading an image into FLASH.
Erasing FLASH The Coldloader is erasing FLASH. After this is
complete, the Flash image can be sent to the node
ERR: Bad FLASH An error occurred while the Cold Loader was loading
an image into FLASH.
Loading FBIST FBIST software is being loaded from FLASH to
SDRAM for execution.
Loading FIPL FIPL software is being loaded from FLASH to
SDRAM for execution.
Loading ONS The operating software is being loaded from FLASH to
SDRAM for execution.
Need ColdLoad The FLASH does not contain a valid software image
and the node is waiting to be ColdLoaded.
--- Node Up --- The node is up and running:
The operating software has begun multi-tasking.
The data ports are enabled.
Data can start passing.
S5.4 [16 characters] Indicates the software version running on the node
including software feature set name (up to 16
characters).
Send FLASH Image The Cold Loader is waiting for a FLASH image to be
sent to the node during the cold load procedure
Testing Node FBIST is running diagnostic tests on the hardware.
Vanguard 6435 or
Vanguard 6455
The model type.
Zap Mode The diagnostic Zap mode is invoked. Force Coldboot
or Clear CMEM commands can be selected.