Vanguard Managed Solutions 6455 Network Card User Manual


 
Hardware Description 2-25
Enhanced Vanguard Daughtercards
Vanguard 6435 and 6455 ATM Compression Support
Introduction Release 6.3 and greater supports the use of compression on a Vanguard 6435 and
6455. Prior to release 6.3 ATM was not designed to support compression over an
AAM station (connecting via PVC to LCON stations).
Main Menu->Configure->Configure Network Services
Figure 2-34. Configure Network Services Menu
ATM Compression Follow the steps in the table below. This configuration allows the data from an
LCON-1 to go out to an ATM station compressed.
Node: 6.3_TEST Address: 63 Date: 7-FEB-1999 Time:1:17:59
Menu: Configure Network Services Path: (Main.6.3)
1. Route Selection Table
2. PVC Setup Table
3. Mnemonic Table
4. Network Services Features Table
5. DSCP-to-CoS Mapping Profile
6. BCUG Table
7. Configure QoS
8. (reserved)
9. (reserved)
10. Redirection Table
Step Action
1 Under the Configure Network Services Menu, select PVC Setup Table.
Entries are:
Source: aam-10s1
Destination: lcon-1
2 Under the Configure Network Services Menu select Network Services
Feature Table.
Entries are:
Port/Station Identifier: lcon-1
Data Compression Level: FORCE_ON
Note
When PVC is configured the Data Compression Level should be set to
FORCE_ON.