Filter
Top Products
3-28 Installation and Replacement
Modifying Your Vanguard 6435/6455
Instructions To install (and remove) Enhanced Vanguard Daughtercards, perform the steps as
shown in Figure 3-14:
Figure 3-14. Enhanced Vanguard Daughtercard Installation
Remove an Enhanced Vanguard Daughtercard
Locate the Enhanced Vanguard Daughtercard
you want to remove and loosen the captive
screws that are holding it to the back panel.
Loosen and remove the two mounting
screws.
Carefully lift out the daughtercard.
1
2
3
Note: Enhanced Vanguard Daughtercards
can be installed in only the two
right-most daughtercard slots as
seen from the rear of the
motherboard.
Mounting Screw Holes
10/100 Base T
Daughtercard
Install an Enhanced Vanguard Daughtercard
Locate the slot where you want to install the
Enhanced Vanguard Daughtercard and
remove the filler panel by loosening the
captive screws.
Carefully position the Enhanced Vanguard
Daughtercard over the connector. Press
down firmly so the daughtercard connector
seats properly with the motherboard
connector.
Secure the Enhanced Vanguard Daughter-
card with the two mounting screws and the
two captive screws on the back panel.
1
2
3