Vanguard Managed Solutions 6455 Network Card User Manual


 
2-12 Hardware Description
Vanguard Daughtercards
If you have an older Vanguard Daughtercard and would like to use it in a Vanguard
6435/6455, contact your service representative about having the card reworked.
DIM Daughtercard This card supports a single V.11, V.24, V.35, or V.36 DIM (Digital Interface
Module) and can be set as either a DTE or DCE.
Figure 2-10 shows the DIM Daughtercard connector as it appears on the back panel.
Figure 2-10. DIM Daughtercard Connector
56 K DSU/CSU
Daughtercard
The DSU Daughtercard provides an RJ48S connector and can support speeds of
56 kbps (synchronous). It conforms to AT&T 62310 point-to-point and multipoint,
and to ANSI T1/E1.4/91-006 56 kbps. The card supports the following capabilities:
Internal/external clocking
Internal/external loopback
4-wire line driver operation
The card also supports multidrop DSUs when either of these conditions exist:
If a MARK Idle protocol is used (such as MX25).
If the Telco uses an OR’ed or Data Contention is used to mix individual DRU
drops.
Figure 2-11 shows the 56K DSU/CSU Daughtercard connector as it appears on the
back panel.
Figure 2-11. 56K DSU/CSU Daughtercard Connector
ISDN BRI-U
Daughtercard
This card provides 2B+D Channel through an ISDN BRI U interface. It conforms to
ANSI T1.601 1992 (2B1Q), is LAPD:ITU Q.921 compliant, and supports the
following:
Integral X.31
Q.931 dial support
NI1, 5ESS, DMS-100 switch types
D Channel Packet Mode
Leased Circuit Services (I Interface)
Japan High-Speed Digital
Figure 2-12 shows the ISDN BRI-U Daughtercard connector as it appears on the
back panel.
DIM SITE
DSU