Vanguard Managed Solutions 6455 Network Card User Manual


 
2-18 Hardware Description
Vanguard Daughtercards
G.SHDSL The G.SHDSL Daughtercard is available for the Vanguard 6435 and 6455 with
Release 6.4 and greater software. Two G.SHDSL Daughtercards are supported
simultaneously in any of the three daughtercard slots.
Warning
A ferrite bead is required on a Vanguard 6435 and 6455. A ferrite bead filters out
line disturbances, on audio and power cables. Installation of a bead is required to
ensure compliance with the European Union (EU) EMC Directive 89/336/EEC and
compliance with FCC Part 15, Class A. Failure to install the ferrite component will
result in non-compliance with the EU EMC Directive and may cause interference
with other electrical equipment.
Figure 2-26 shows the rear panel connector on the G.SHDSL Daughtercard. For
information on the G.SHDSL Daughtercard reference the G.SHDSL Manual
(Part Number T0100-14). Daughtercard and Ferrite Bead Installation instructions are
available in the Daughtercard Installation Guide (Part Number T0020).
Figure 2-26. G.SHDSL Daughtercard Connector
G.SHDSL
CD
WAN
MR
LP