Filter
Top Products
030-300536 Rev. A 160 August 2007
User GuideVersaLink Wireless Gatewa
y
(
Model 7500
)
16.18 Private LAN—Configuring NAT
In the Advanced screen, click Private LAN. The following screen will appear. Private LAN allows you to set up a
network behind your Router.
If you change the settings in this screen, click Apply. If you click Reset, the screen will refresh and the previously
saved settings will remain active.
IMPORTANT: Whenever you change the settings in a screen, the screen will display the changes; however, you must
click Apply to allow the changes to take effect in the Router. (Private LAN is the default setting for VersaLink.)
Private LAN
Private LAN DHCP Server Enable Default = Enabled
If this box contains a check mark, this enables DHCP addresses to be
served from the Private LAN pool.
Private LAN Enable Default = Enabled
If this box contains a check mark, this enables the addresses from the
Private LAN to use the NAT interface.
Modem IP Address Displays the Router’s IP address.
Subnet Mask Displays the Subnet Mask, which determines what portion of an IP
address is controlled by the network and which portion is controlled by the
host.
DHCP Start Address Displays the first IP address that the DHCP server will provide.
DHCP End Address Displays the last IP address that the DHCP server will provide.
DHCP Lease Time Displays the amount of time the provided addresses will be valid, after
which the DHCP client will usually resubmit a request.
Note: The DHCP Lease Time value must be greater than 10 seconds. The default = 01:00:00:00. Seconds must be
between 0 and 59, minutes must be between 0 and 59, and hours must be between 0 and 23.