Filter
Top Products
030-300536 Rev. A 92 August 2007
User GuideVersaLink Wireless Gatewa
y
(
Model 7500
)
14.2.3.3 Editing the VC Protocol Settings for Ethernet WAN Uplink
NOTE: The instructions in this section refer to the Router configured for Ethernet WAN Uplink mode. Be sure that
you have selected Ethernet WAN Uplink in the VersaPort screen.
14.2.3.3.1 Configuring the WAN Uplink Protocol Settings for PPPoE
After you have selected Ethernet WAN Uplink, in the preceding steps, select the desired protocol from the
Protocol drop-down menu. If you select PPPoE, the following screen will appear. Select the desired options, and
then click Apply to save the settings.
NOTE:
1. If you experience any problems, reset the Router by pressing the reset button on the rear of the Router. Or follow
the instructions in section 16.2, “Restore Defaults,” to restore the Router to factory default settings. The actual
information displayed in this screen may vary, depending on network connection established.
2. PPPoE is the factory default setting for Ethernet WAN Uplink.
Uplink Settings for Ethernet WAN Uplink (PPPoE protocol)
Tunneling Factory Default = Enable
If Enabled, this option allows PPP traffic to be bridged to the WAN. This feature
allows you to use a PPPoE shim on the host computer to connect to the Internet
Service Provider, by bypassing the Router’s capability to do this. Factory default is
“Enable.”
Secondary WAN Factory Default = Disable
The secondary WAN interface is used for multicast traffic. This feature applies only
when you are using PPPoE as the Primary WAN protocol.