Filter
Top Products
Troubleshooting 137
1. Type the following commands at the System Console screen (where XXX is
the new numeric value):
Set Minimum Packet Receive Buffers=XXX
Set Maximum Packet Receive Buffers=XXX
2. Add the commands to the STARTUP.NCF file.
NOTE: When gigabit NICs are installed, the minimum buffers should be
set to at least 500, and the maximum to at least 2000.
NetWare attempts to load MEGA4 XX.HAM or 120PCI.HAM during installation, and a
RILOE II board is installed
Action: No action is required. This occurrence does not impact the installation of
NetWare.
During installation of Sun Solaris, the system locks up or a panic error occurs
Action: Disable ACPI support in Sun Solaris. Refer to the Sun website
(http://www.sun.com
) for documentation on how to disable ACPI.
Operating System Updates
Use care when applying operating system updates (Service Packs, hotfixes, and
patches). Before updating the operating system, read the release notes for each
update. If you do not require specific fixes from the update, it is recommended
that you do not apply the updates. Some updates overwrite files specific to HP.
If you decide to apply an operating system update:
1. Perform a full system backup.
2. Apply the operating system update, using the instructions provided.
3. Install the current drivers ("Maintaining Current Drivers" on page 141
).
If you apply the update and have problems, refer to the Software and Drivers
Download website (http://h18007.www1.hp.com/support/files/server
) to find
files to correct the problems.