Filter
Top Products
Xerox 4112/4127 Copier/Printer User Guide
12-2
12. Problem Solving
Symptoms Causes and Actions
Power is not switched On. YES Cause Is the power switch on the machine turned off?
If NO, go to next sympton. Action Turn the power switch on.
Refer to “Power on/off” on page 1-13.
If problem is not solved, go to next Cause/Action.
Cause Is the power cord plugged into the power outlet?
Action Turn the power switch off and then firmly plug in the power
cord. Then turn the power switch on.
Refer to “Power on/off” on page 1-13.
If problem is not solved, go to next Cause/Action.
Cause Is the power cord disconnected from the machine or the
rear of the rack?
Action Turn the power switch off and then firmly plug in the power
cord. Then turn the power switch on.
Refer to “Power on/off” on page 1-13.
If problem is not solved, go to next Cause/Action.
Cause Is power of the correct voltage being supplied?
Action Make sure that the power supply is 200 -240 V (volts),
15 A (amperes).
Make sure that power of capacity compatible with the
specified maximum power consumption of the machine
(2.8 - 3.1 KVA) is being supplied.
Display is dark. YES Cause Is the Power Saver button on?
If NO, go to next sympton. Action The machine is in the Power Saver mode. Press the
Power Saver button on the Control Panel to cancel the
Power Saver mode.
Refer to “Power Saver Mode” on page 1-15.
If problem is not solved, go to next Cause/Action.
Cause Is the Brightness Dial set too low?
Action Use the Brightness Dial to adjust display brightness.
Refer to “User Interface (UI)” on page 1-7.
A message is displayed. YES Cause Has a paper jam or document jam occurred?
If NO, go to next symptom. Action For information on paper jams, refer to “Paper Jams” on
page 12-45.
For information on document jams, refer to “Document
jams” on page 12-76.
If problem is not solved, go to next Cause/Action.
Cause An error code displayed?