Filter
Top Products
Monitor Menu:
Appendix A: Telnet and NBMON command mode options ❖ A-5
Display/set ethernet
options:
Command [?,C,D,E,F,H,I,L,N,P,Q,R,S,Z,*,+] --> E
(note: Aux port is now set in the sockets section of the
Network protocols menu)
Link test is enabled
Link test
1 (disabled)
2 (enabled)
<enter> (don't change/continue)
Link test is now enabled
Flash firmware load
enable/disable:
Command [?,C,D,E,F,H,I,L,N,P,Q,R,S,Z,*,+] --> F
Flash load is enabled.
Ver 1.56, dt 8/25/1998 14:48, (seqNum=1)
Flash load currently is enabled. Disable, yes or no (y or
n)?:n
Display/set IP
address:
Command [?,C,D,E,F,H,I,L,N,P,Q,R,S,Z,*,+] --> I
current IP address: not set. ( 13.231.38.195 set by DHCP ).
Enter new IP address (<cr> for no change):