Filter
Top Products
Windows NT 4.0 Network
4-12 ❖ DocuPrint Technical Information Guide
Windows NT 4.0 Network
Introduction
Your printer can be installed on a Windows NT network
using one of three methods:
• TCP/IP protocol
• DLC/LLC protocol
• AppleTalk protocol
The
Preliminary Steps
given below must be accomplished
for all printers regardless of the protocol that is being used.
Then, the
Quick Install Steps
will detail the installation
based on the protocol used on your network.
The CentreWare DP program on your Printer
Management Software CD-ROM can also be used to
monitor and configure the printer.
Preliminary Steps
1
Print the Configuration Sheet. Details are in
Chapter 2: Connecting to Your Network
,
“Print the
Configuration Sheet” (page 2-21)
. Retain this page for
reference.
2
Check the Configuration Sheet and verify that both the
desired protocol and connector are enabled.
3
Proceed to the Quick Install Steps for your network
protocol.