Filter
Top Products
165
MSAP2000 AAM User’s Guide
Figure 87 Log Show Command Example
ras> sys log show
1 Wed Aug 11 20:37:11 2004 telnetd INFO Session Begin!
2 Wed Aug 11 20:37:05 2004 telnetd INFO Session Begin!
3 Wed Aug 11 20:36:56 2004 telnetd INFO Session Begin!
25.2.19 Log Clear Command
Syntax:
ras> sys log clear
This command clears the system error log.
Note: If you clear a log (using the log clear command), you cannot view it again.
25.2.20 Monitor Show Command
Syntax:
ras> sys monitor show
This command displays the hardware monitor’s statistics.
An example is shown next.
Figure 88 Monitor Show Command Example
ras> sys monitor show
Hardware monitor status: enabled
limit(hi) limit(lo)
--------- --------- v1(v)
1.344 1.056 v2(v) 1.944
1.656 v3(v) 3.564 3.036
v4(v) 19.440 16.560
t1(c) 97.0 -55.0
t2(c) 97.0 -55.0
t3(c) 97.0 -55.0
25.2.21 Monitor Vlimit Command
Syntax:
ras> sys monitor vlimit <idx> <high> <low>