Filter
Top Products
210
MSAP2000 AAM User’s Guide
This command shows information about the specified port’s VLAN settings.
The following example shows the settings for all VIDs.
Figure 125 VLAN Show Command Example
ras> switch vlan show *
vid name F:fixed X:forbidden N:normal U:untag T:tag
---- ---------------- ---------------------------------------------------
1 DEFAULT
enabled 123456789012 12
FFFFFFFFFFFF
FF
UUUUUUUUUUU
U UU
2 test2
enabled 123456789012 12
FXXXXXXXXXXX
NN
U----------- TT
3 test3
enabled 123456789012 12
FXXXXXXXXXXX
NN
U----------- TT
200 test200
enabled 123456789012 12
XXXXXXXXXXXX
FN
------------ UT
27.11 MAC Filter Commands
Use the MAC filter commands to allow only incoming frames from MAC (Media
Access Control) address(es) that you specify. MAC filter commands are listed
next. You may specify up to ten MAC addresses per port.
27.11.1 MAC Filter Show Command
Syntax:
switch mac filter show [portlist]
where
[portlist]
= You can specify a single ADSL port <1>, all ADSL
ports <*> or a list of ADSL ports <1,3,5>. You can also
include a range of ports <1,5,6~10>.
This command displays the MAC filtering status (V for enabled, - for disabled)
and the fixed source MAC addresses on the specified ADSL port(s) or on all
ADSL ports if no port is specified.