Filter
Top Products
239
MSAP2000 AAM User’s Guide
Quit FTP.
ftp> quit
31.3.2 Edit Configuration File
Open the config-0 file via notepad (see the following example) and edit to a
desired configuration.
Note: Ensure that any changes you make to the commands in the configuration
file correspond to the commands documented in this User’s Guide.
Figure 150 Configuration File Example
#### sysinfo
sys info hostname ras
sys info location taiwan sys
info contact zmlin
#### snmp
sys snmp getcommunity public sys
snmp setcommunity public sys
snmp trapcommunity 1234 sys
snmp trustedhost 0.0.0.0
sys snmp trapdst 172.23.15.250
#### server
sys server enable telnet sys
server enable ftp
sys server enable web sys
server enable icmp
sys server port telnet 23
sys server port ftp 21
sys server port web 80
#### client
sys client set telnet 0.0.0.0 sys
client set ftp 0.0.0.0 sys client set
web 0.0.0.0 sys client set icmp
0.0.0.0
#### syslog
sys syslog enable
sys syslog server 172.23.15.240
sys syslog facility 1
#### timeserver
sys timeserver set time 172.23.15.240 utc+0800 nosync
#### watchdog
sys wdog set 10000
31.3.3 Editable Configuration File Upload
You can upload the configuration file by following the steps below.
Use an FTP client to connect to the MSAP2000 AAM.
C:\> ftp <MSAP2000 AAM IP address>