Filter
Top Products
215
MSAP2000 AAM User’s Guide
where
<portlist>
= You can specify a single ADSL port <1>, all ADSL
ports <*> or a list of ADSL ports <1,3,5>. You can also
include a range of ports <1,5,6~10>.
<count> = Set the limit for how many MAC addresses that a port
may dynamically learn. For example, if you are
configuring port 2 and you set this field to "5", then
only five devices with dynamically learned MAC
addresses may access port 2 at any one time. A sixth
device would have to wait until one of the five learned
MAC addresses ages out.
The valid range is from “1” to “1024”.
This command sets the limit for how many MAC addresses may be dynamically
learned on the specified ADSL port(s).
Note: If you also use MAC filtering on a port, it is recommended that you set the
MAC count to be equal to or greater than the number of MAC filter entries
you configure.
The following example sets the MAC count filter to allow up to 50 MAC
addresses to be dynamically learned on ADSL port 7.
Figure 134 MAC Count Set Command Example
ras> switch mac count set 7 50
27.13 Packet Filter Commands
Use the following packet filter commands to filter out specific types of packets
on specific ports.
27.13.1 Packet Filter Show Command
Syntax:
switch pktfilter show [portlist]
where
[portlist]
= You can specify a single ADSL port <1>, all ADSL
ports <*> or a list of ADSL ports <1,3,5>. You can also
include a range of ports <1,5,6~10>.