Filter
Top Products
set ntp update-interval 149
History —Introduced in MSS Version 3.0.
Usage — You can configure up to three NTP servers. MSS queries all the
servers and selects the best response based on the method described in
RFC 1305, Network Time Protocol (Version 3) Specification,
Implementation and Analysis.
To use NTP, you also must enable the NTP client with the set ntp
command.
Examples — The following command configures a WX switch to use
NTP server 192.168.1.5:
WX4400# set ntp server 192.168.1.5
See Also
clear ntp server on page 113
clear ntp update-interval on page 113
display ntp on page 126
set ntp on page 148
set ntp update-interval on page 149
set ntp
update-interval
Changes how often MSS sends queries to the NTP servers for updates.
Syntax — set ntp update-interval seconds
seconds — Number of seconds between queries. You can specify
from 16 through 1,024 seconds.
Defaults — The default NTP update interval is 64 seconds.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Examples — The following command changes the NTP update interval
to 128 seconds:
WX4400# set ntp update-interval 128
success: change accepted.