Filter
Top Products
set system ip-address 155
Usage — You must first set the time zone with the set timezone
command for the offset to work properly without the start and end
values.
Configure summertime before you set the time and date. Otherwise,
summertime’s adjustment of the time will make the time incorrect, if the
date is within the summertime period.
Examples — To enable summertime and set the summertime time zone
to PDT (Pacific Daylight Time), type the following command:
WX1200# set summertime PDT
success: change accepted
See Also
clear summertime on page 115
clear timezone on page 116
display summertime on page 130
display timedate on page 130
display timezone on page 131
set timedate on page 156
set timezone on page 157
set system
ip-address
Configures the system IP address. The system IP address determines the
interface or source IP address MSS uses for system tasks, including the
following:
Mobility domain operations
Topology reporting for dual-homed MAP access points
Default source IP address used in unsolicited communications such as
AAA accounting reports and SNMP traps
Syntax —
set system ip-address ip-addr
ip-addr — IP address, in dotted decimal notation. The address must
be configured on one of the WX switch’s VLANs.
Defaults — None.
Access — Enabled.