Filter
Top Products
set port type wired-auth 87
Syntax — set port type wired-auth port-list [tag tag-list]
[max-sessions num]
port-list — List of physical ports.
tag-list — One or more numbers between 1 and 4094 that
subdivide a wired authentication port into virtual ports.
num — Maximum number of simultaneous user sessions supported.
Defaults — The default tag-list is null (no tag values). The default
number of sessions is 1.
Access — Enabled.
History—Introduced in MSS Version 3.0.
Usage — You cannot set a port’s type if the port is a member of a port
VLAN. To remove a port from a VLAN, use the clear vlan command. To
reset a port as a network port, use the clear port type command.
When you change port type, MSS applies default settings appropriate for
the port type. Table 18 lists the default settings that MSS applies when
you set a port’s type to ap.
Examples — The following command sets port 2 for a wired
authentication user:
WX1200# set port type wired-auth 2
success: change accepted
Table 18 Wired Authentication Port Details
Port Parameter Setting
VLAN membership Removed from all VLANs. You cannot assign an MAP access
port to a VLAN. MSS automatically assigns MAP access ports
to VLANs based on user traffic.
Spanning Tree
Protocol (STP)
Not applicable
802.1X Uses authentication parameters configured for users.
Port groups Not applicable
IGMP snooping Enabled as users are authenticated and join VLANs.
Maximum user
sessions
1 (one).