Filter
Top Products
288 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
Defaults — By default, MAP access points send the DTIM once after
each beacon.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — You must disable all radios that are using a radio profile before
you can change parameters in the profile. Use the set radio-profile
mode command
.
The DTIM interval does not apply to unicast frames.
Examples — The following command changes the DTIM interval for
radio profile rp1 to 2:
WX4400# set radio-profile rp1 dtim-interval 2
success: change accepted.
See Also
display radio-profile on page 257
set radio-profile mode on page 291
set radio-profile
frag-threshold
Changes the fragmentation threshold for the MAP radios in a radio
profile. The fragmentation threshold specifies the maximum length a
frame is allowed to be without being broken into multiple frames before
transmission.
Syntax —
set radio-profile name frag-threshold threshold
name — Radio profile name.
threshold — Maximum frame length, in bytes. You can enter a value
from 256 through 2346.
Defaults — The default fragmentation threshold for MAP radios is 2346
bytes.
Access — Enabled.
History —Introduced in MSS Version 3.0.