set igmp qri 361
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — The query interval is applicable only when the WX is querier for
the subnet. For the WX switch to become the querier, the pseudo-querier
feature must be enabled on the WX and the WX must have the lowest IP
address among all the WX switches eligible to become a querier. To
enable the pseudo-querier feature, use the set igmp querier command.
Examples — The following command changes the query interval on
VLAN orange to 100 seconds:
WX1200# set igmp qi 100 vlan orange
success: change accepted.
See Also
■ “set igmp lmqi” on page 356
■ “set igmp oqi” on page 359
■ “set igmp qri” on page 361
■ “set igmp querier” on page 362
■ “set igmp mrouter” on page 356
■ “set igmp rv” on page 364
set igmp qri Changes the IGMP query response interval timer on one VLAN or all
VLANs on a WX.
Syntax —
set igmp qri tenth-seconds [vlan vlan-id]
■ qri tenth-seconds — Amount of time (in tenths of a second) that
the WX waits for a receiver to respond to a group-specific query
message before removing the receiver from the receiver list for the
group. You can specify a value from 1 through 65,535.
■ vlan vlan-id — VLAN name or number. If you do not specify a
VLAN, the timer change applies to all VLANs.
Defaults — The default query response interval is 100 tenths of a second
(10 seconds).
Access — Enabled.
